Obracałem D-sonica, różnica minimalna... Tak samo bezpłciowo .
Sztabką do gryfu ma więcej środka ... ale Wujo dobrze powiedział haha
Jeżeli komuś nie chciało się czytać pickupology (które mówi o tym, że wyśmiewa definiowanie na podstawie jednego parametru)
Proszę:
2. The efficiency of a pickup is the result of many factors.
The number of turns per square.
The relation between the length and the cross section of its coil or coils.
The diameter of the coil wire.
The permeability of the core.
The hysteresis of the core.
The permeance coefficient of the magnetic circuit ( B/H).
The energy product of the magnetic circuit ( Bd Hd.)
Remember, a pickup is NOT a power generator, and the magnitudes of volts, amps and watts are extremely small; but, regardless how many turns you put on a pickup, you will NEVER get 100 watts out of a 50 watt amp.
3. The distance between pickup and string is a very important factor for output and sound.
As a general rule for the bridge pickup - put a nickel on top of the pickup under the high E string and play the highest note on that string. Adjust the height on that side of the pickup till the string touches the nickel. Repeat the same with the low E string, but use two nickels on top of each other. If this gives you too much output, you can reduce the height slightly. Don't forget that twice the distance will reduce the output by about 60%, and the sound will lose some lows. NOW, you can adjust the neck pickup to match the output of the bridge pickup. For the sound test, use stage volume.