Wiadomość #308674

[Zomballo]

pisałem a propos:

Po roku oczekiwań pojawił się nowy updejt do HD. Z tego co wyczytałem nic nie robi.

Men! Od tamtego 2.0 już ponad rok minął a teraz wypuśli jakąś zapchajdziurę v2.2 która robi wielkie nic.

Version 2.20.00
Released 11/19/13

 Works with:
POD HD500    
POD HD500 Flash Memory v2.2 RELEASE NOTES 

 POD HD500 Flash Memory v2.2 is a FREE firmware update for all POD HD500 users.  Before updating your firmware it is strongly recommended that you connect to the POD HD500 Edit application and back up any presets you may wish to keep so you may install the latest factory presets as part of the firmware update.

What’s New? 
Significant improvement to the integration of StageSource speakers and DT amplifiers connected via L6 LINK
Master knob on the POD now attenuates the level sent to connected L6 LINK devices*
POD output mode defaults to Studio/Direct when connecting StageSource speakers
StageSource speakers default to Reference (FRFR) mode**
Preset switching optimizations
StageSource speakers no longer mute upon preset switching unless the speaker mode differs
Output of the Looper (in the post position) no longer mutes upon preset switching
Pressing the Reverse switch while using the Looper's Overdub feature no longer causes audible artifacts
General bug fixes and optimizations

 * Previous firmware versions had no attenuation at the output to L6 LINK connected devices - for the same results simply turn the Master knob to maximum

 ** Note that any previously saved presets will retain any StageSource speaker modes that were set at the time the POD presets were saved

Known Issues
When mixing both StageSource speakers and DT amplifiers over L6 LINK, DT amps must be connected before any StageSource speakers for audio to pass through to all L6 LINK connected devices
Variax Workbench HD will not connect via POD HD - use the VDI/USB interface included with your JTV as a workaround