Wiadomość #349668

[Dun]

Pusty patch nie powinien szumieć; u mnie w 5150 jest cisza (POD HD500). Opcja 1/4 out ustawiona na AMP nie LINE o ile mnie pamięć nie myli, master na 100%, w globalnych ustawieniach mam Studio/Direct.

Na pierwszy rzut warto posłuchać Zombiego - może poszedł któryś z kabli. Jeśli nie to jest przyczyną, to może nieprawidłowe podłączenie i/lub ustawienia? Powinno to wyglądać w ten sposób (podjebano z forum Line 6'a):

Wire your guitar, the HD500 and amp together as follows:

Guitar > HD500 Input > HD500 FX Send (using a mono
cable) > Amp front input. Amp FX Send > HD500 L/Mono
Return. HD500 Left Out > Amp FX Return

To hear just the sounds of your amp:

To just hear the sounds of your amp you would need a NULL preset to be set up
in your HD500 - meaning no FX or Amp modelling. The POD will just route
your amp's preamp signal through to the power amp stage. There may be some
slight coloration doing this as you will be passing the signal through the
HD500's circuitry.
How? Set up a blank preset which has NO effects EXCEPT the FX Loop set to
100% output and 100% mix - you may need to adjust these levels to achieve
similar levels to your amp with nothing plugged in. Make sure the FX Loop is
turned ON on the HD500. Also ensure there are no amp models loaded. IF
your amp's FX loop is switchable, you may be able to bypass the bulk of the
HD500's circuitry by simply bypassing the HD500 in the amp's loop (but your
guitar will still go via the input of the HD500 before it gets to the front input on
the guitar amp)

To use the HD500's FX with your amp's pre-amp and power amp:

How? Set up an HD500 preset with NO amp or cab models loaded. For an
example put a Wah at the start of the chain followed by any distortion FX you
want say Screamer. Follow this with the FX Loop effect so it's placed BEFORE
the mixer block. After the mixer block place modulation, delay and reverb for
example. Make sure the FX Loop is ON and the Mix level is set to 100%

To use the HD500's full modelling feature set and your amp's Power Amp only:

How? Set up the HD500 as you would normally with Wah and Distortion type
FX before the amp block/mixer block. Add in an amp model of your choice.
Add in Modulation, Delay and Reverb or whatever after the Mixer block, But
DON'T include the FX Loop effect anywhere in this signal chain.
Note: The FX Loop isn't traditionally what I would term an 'effect' but for the
purposes of this it behaves like an effect and falls within the FX group in the
HD500, so that';s why I have referred to it as an 'effect'.

P.S. - podłączasz do EVH?